FILMENTUM MAGIGOO for HT adhesive stick for better adhesion of Peek 50ml material

Magigoo is an easy -to -use liquid "adhesive" designed to solve your problem with the adhesion of the first layer, a basic problem in 3D printing of FDM technologies. In case of poor adhesion, the printing is separated from the print platform itself. Good adhesion of the first layer is important, as this layer forms the basis for the rest of the press. Magigoo was specially designed for universal use. So it works equally well for PLA, as well as ABS and other filaments.

High -temperature fibers have generally proved to be demanding material for printing FDM technologies due to their higher susceptibility to deformation. MAGIGOO PRO HT is a specialized solution for FDM Print Strune Peek and Pekk, which is activated just at high print temperatures.

Magigoo is easy to clean with water - which is the most common and affordable solvent. After each printing it can be cleaned with a damp cloth to prevent excess accumulation of Magigoo.

Adhesive properties of Magigoo are designed to hold the model during printing and release it after cooling. During the cooling process, you will hear a distinctive rupture sound. This will reach the printing of the print from the pad and after completely cooling 3D prints can be easily removed without the use of tools and excessive force.

Magigoo helps in multi -hour prints where it really depends on not to deformation and grip problems and your long printing is fine.

lasts more than 100 uses. It is soluble in water and is therefore easy to clean.

1. Removing the sealing foil
Before use, it is necessary to remove the wheel from the seal that prevents drying and spilling during transport. Unscrew the applicator cover and remove the sealing foil.
2. Apply the product
to the print pad a continuous thin film to ensure the adhesion of the print to the mat. Once the product is applied, the bottle is recommended that the inner liquid does not dry, which could cause clogging the applicator.
3. Printing of the model
Magigoo can be used for 3D printers with heated and unheated printing pad.
4. Removing the model from the pad
When printing, the connection between the materials is very strong as soon as the room temperature is cooling, the printing can be removed without the use of violence.
5. Cleaning the pad
If the rest of the product is unevenly distributed by printing, it is advisable to wipe the pad at the point of use with a damp cloth. For further printing, you can apply a new layer and allow it to dry.