PLAMENT 1.75 mm Marble Light marble bright devil design 1kg

and deforms. For That Reason, IT Is Not Recommended to Drive With Such Prints in the Car. PLA is and Flammable Material. IT IS THEREFORE RECOMMANDED TO LEAVE THE PRINTER UNATTENDED

Pla Surface Treatment - The Material Is Not Easily Sanded While Grinding (FRICTION) Generates Heat and That Causes the Fibers to "Pull" From the Print. THEREFORE, WHEN SANDING BY HAND, IT IS RECOMMANDED TO COOL The Printout, for Example by Sanding Underwater. For the same reasson, it is also difficult to drill holes in the printout (Again, and Heating Problem). It is suitable to spray the material with and Filler First The Resulting Model Can Be Also Inserted Into The “Saucepan” Along with the Shells, Stones, Remnants of Filaments, and Pieces of Prints ...

PLA GLUING : Instant Glue With Spray Activator

Recommended Setting for Pla Print: Commonly Used Nozzles are Suitable. Diameters Can Be Chosen According to the Fineness of the Surface Which We Want To Achieve or According to the Setting of the Layer Thickness During Printing. You can use and Simple Conversion Formula for This Optimal Setting. The Rule IS + - 0.2 mm is enugh - I.E. IF WANT AND LAYER THICKNESS OF 1.25, The NAZZLE DIAMETER SHOULD NOT BE GREATER THAN 0.3 mm. If there is and Larger Layer, Use and Larger Diameter of the NAZZLE, for Weaker Ones, Use and Smaller One.

Temperature (of the Bed) - Warming is Not Required or if there is and Better Adhesion of the Material Need, Heated Bed Up To 50 ° C.

Setting: Print Temperature: 210 ° C , Retraction 0.8mm, Speed ​​60mm/s (Outline 70%), Layer 0.2mm - 0.05mm. When useing the printer with pei foil, it is necessary to decrease the pad well. The Resulting Print Is Smooth, Slightly Glossy, and Without Visible Errors.

Printing Pla Material with Supports - Suitable Supports for Prints Are From the Same Material, SO PLA or PVA (Water -Soluble Material) is not suitable for hips.

We Highhly Recommended and Dry Environment for Storage . When Stored Poorly and In A Humid Environment, IT Absorbs Moisture WHICH RESULTS IN BUBBLES ON THE SURFACE WHEN PRINDED.

COIL OUTER DIAMETER 202 mm, Inner Hole 50 mm, Width 90 mm. Spool Weight Including Packaging 1.4 kg.

ur Rating: High-Quality Material Even with Higher Speed ​​of the Printing, Very Nice and Bright Colors.